It's starting to stick!

So I've given my silicone adhesive/sealant a go. It's both things... Couldn't decide between the two! 

First of all I needed a padded spacer to smooth the gap between silicone face and helmet

Made this from foam

Then glued it down

Then once that had started to set.. Glued the mesh down to it. I had left 10-20mm gap around the edges knowing this would end up wing glued. If there's any spare holes I will latch them after..

Also tried a little patch of it on the mask to see if it adheres to it.. Will see tomorrow!!

I bough a fancy sealant - It comes with a shut off valve and different sized nozzles. Gonna e great using the micro one for doing the face fur